BOP Test Flange

Flanged Diverter Spool

API 16A Clamps for Clamp Hub Connections

Flanged Drilling and Spacer Spools

Snubbing Stack Spools and Adapters

5-1/8" 15m Spacer Spools

7-1/16" 15M Spacer Spool and Adapters

7-1/16" 5M Well Cement System Spools and Fittings

Offset Entry Spool

Choke Manifold Buffer Tanks

BOP Riser/Spacer Spools

Spacer Spools for Sour Service

BOP Lift Flange

45° Studded Tees

Lift Hub

Fabricated Spacer Spools

WOODCO USA manufactures all types of test flanges, loose with tapped holes, mounted on a base plate, and custom test flanges (as above).

WOODCO USA offers diverter spools manufactured to ANSI, API Spec 6A, and API Spec 16A requirements as customers request.

WOODCO USA manufactures clamps to fit all current API Spec 16A hubs, and older Cameron made hubs.

WOODCO USA manufactures fabricated flanged drilling spools and spacer spools to API Spec 6A and 16A requirements. All API Spec 6A, PSL-2 and PSL-3, as well as API Spec 16A spools, have full penetration welds with 100% volumetric inspection of the weld after final stress relief.

WOODCO USA offers API Spec 6A flanged, studded, and union connected snubbing fittings. These units of equipment, manufactured without welding of any kind, meet API Spec 6A, PSL-3 requirements.

WOODCO USA offers spacer spools in sizes through 7-1/16" 5M, up to 10 feet long, made without fabrication welding.

WOODCO USA manufactures PSL-3 snubbing spools and adapters for sour service without fabrication welding.

WOODCO USA fabricates spools and fittings including, swivel tees.

Fittings fabricated with API Spec 6A lubricator and Figure # connectors.

WOODCO USA manufactures manifold buffer tanks with the same working pressure as the lowest pressure connector. Units receive the same hydrostatic test as a spool with the same flanges. Buffer tanks made by WOODCO USA may bear the API Monogram.

WOODCO USA manufactures spacer spools to meet API Spec 6A or 16A requirements.

WOODCO USA one piece flanged spacer spools meet NACE and API requirements.

WOODCO USA lift flanges allow the safe attachment of hoisting equipment to lift the BOP stack.

WOODCO USA manufactures wellhead tees from 410 stainless steel to meet API Spec 6A FF material requirements.

WOODCO USA lift hubs allow the pulling of BOP choke manifold flexible spools and the lifting of clamp connected snubbing stacks.

WOODCO USA fabricated spacer spools meet all API and NACE requirements.