Catalog for WOODCO USA Clamps for Clamp Hub Connections

Page 15 

WOODCO USA presents this catalog to gain your attention and secure your business

Phone: 713-672-9491

Appendix B

Clamp Identification Worksheet
(For Hubs Click Here)
To identify a Clamp by basic dimensions, measure the Clamp dimensions indicated on the drawing below and provide this information to WOODCO USA, or See Clamp Slide Rule Program on this web site.
USING A SCALE OR MEASURING TAPE:
      
1. MEASURE THE CLAMP INSIDE DIAMETER (I.D.).
     
2. MEASURE THE INTERNAL GROOVE HEIGHT (OR WIDTH).
     
3. MEASURE CLAMP HEIGHT (OR WIDTH) AS MEASURED THRU THE I.D. BORE.
   
4. MEASURE BOLT LENGTH 4A AND DIAMETER 4B.
   
5. MEASURE TAPPED HOLES 5A AND 5B.

1 2 3 4 5

CLAMP
INSIDE DIAMETER (I.D.)

 INTERNAL GROOVE HEIGHT MEASURED THRU I.D. CLAMP HEIGHT MEASURED THRU I.D. BOLT LENGTH AND DIAMETER TAPPED HOLES
      A B A B
CLAMP 1. __________ __________  __________  ______  ______  ______  ______
CLAMP 2. __________ __________  __________  ______  ______  ______  ______
CLAMP 3. __________ __________  __________  ______  ______  ______  ______
CLAMP 4. __________ __________  __________  ______  ______  ______  ______
To obtain more information about WOODCO USA Clamps, click on this catalog's Table of Contents. To obtain more information about Clamp Hub Connection Equipment, see the WOODCO USA Catalog for Pressure Control Equipment.

 www.woodcousa.com